BlackFriday 2024! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

Nutanix Exam NCM-MCI-5.15 Topic 6 Question 76 Discussion

Actual exam question for Nutanix's NCM-MCI-5.15 exam
Question #: 76
Topic #: 6
[All NCM-MCI-5.15 Questions]

An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the following considerations:

* Individual VMs will likely generate network throughputs in the range of 90-100Mbps

* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time

* Individual VMs will communicate with only a few (one or two) remote hosts at a time

* Multicast will not be used in the environment

* The hosts are connected via two 1GbE network connections

How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?

Show Suggested Answer Hide Answer
Suggested Answer: A

by Justine at Feb 10, 2024, 09:26 AM

Limited Time Offer

25%

Off

Get Premium NCM-MCI-5.15 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Ria
4 months ago
That's a valid point, active-backup could simplify the switch configuration while still providing some level of redundancy.
upvoted 0 times
...
Dalene
4 months ago
I disagree, I believe configuring bond0 as active-backup would be simpler and still meet the requirements.
upvoted 0 times
...
Ria
4 months ago
Well, based on the network throughputs and the communication pattern of the VMs, balance-tcp would provide optimal performance.
upvoted 0 times
...
Val
4 months ago
Why do you think that option is the best choice?
upvoted 0 times
...
Ria
5 months ago
I think the administrator should configure bond0 as balance-tcp.
upvoted 0 times
...
Arlene
5 months ago
Balance-lacp utilizes link aggregation which can provide higher bandwidth and fault tolerance.
upvoted 0 times
...
Huey
5 months ago
Why do you think balance-lacp is a better choice?
upvoted 0 times
...
Arlene
5 months ago
I disagree, I believe configuring bond0 as balance-lacp would be more suitable for this scenario.
upvoted 0 times
...
Huey
5 months ago
Well, balance-tcp provides better load balancing compared to the other options like active-backup.
upvoted 0 times
...
Bette
6 months ago
Why do you think balance-tcp is the best option?
upvoted 0 times
...
Huey
6 months ago
I think the administrator should configure bond0 as balance-tcp.
upvoted 0 times
...

Save Cancel