Free Preparation Discussions
MENU
Nokia 4A0-116 Exam Questions
- Topic 1: Configuring segment routing LSPs with traffic engineering constraints/ Configuring IS-IS to advertise TE information
- Topic 2: Differences between segment routing and other traditional MPLS label signaling protocols/ MPLS data encapsulation and forwarding
- Topic 3: Steering traffic into flex-algo segment routing tunnels/ Advertisement of flex-algo information by IS-IS
- Topic 4: Link-state routing protocol extensions to support traffic engineering/ Configuring OSPF to advertise TE information
- Topic 5: Link-state routing protocol extensions to support segment routing/ Configuring OSPF to support segment routing
- Topic 6: Topology-Independent Loop-Free Alternate (TI-LFA) paths/ Remote Loop-Free Alternate (R-LFA) paths
- Topic 7: Advertisement of flex-algo information by OSPF/ Flexible algorithm configuration/ Flexible algorithm basics
- Topic 8: Segment routing tunnels with traffic engineering constraints/ Enabling traffic engineering
- Topic 9: Using segment routing tunnels that follow the IGP shortest path/ Basic segment routing configuration and operation
- Topic 10: Using segment routing tunnels with TE constraints (SR-TE)/ Label stack reduction for CSPF-calculated paths
- Topic 11: Configuring segment routing LSPs calculated by the PCE/ SR-TE with a path computation element
- Topic 12: Local calculation of a TE-constrained LSP path/ Secondary LSP paths and seamless-BFD/ Ensuring LSP path diversity
- Topic 13: Precedence of the different LFA options/ Enabling segment routing fast re-route/ Path Computation Element Protocol (PCEP)
Free Nokia 4A0-116 Exam Actual Questions
Note: Premium Questions for 4A0-116 were last updated On Aug. 28, 2024 (see below)
Which of the following is not required to be advertised by a router participating in Segment Routing?
SRGB when SRv6 is configured: This is not required to be advertised, SRGB(Segment Routing Global Block) is only used for SR-MPLS and is not needed when SRv6 is configured. Instead, SRv6 uses the IANA-assigned IPv6 address space.
Based on the exhibit, and given that the system IP address of router RIO is 10.10.10.10, which of the following statements is FALSE?
Based on the configuration shown for routers R1 and R10, what valid flex-algo definitions exist in the network?
To create a flex-algo instance in a network, which of the following configuration steps is mandatory?
To create a flex-algo instance in a network, it's mandatory to configure at least one router in the network to create and advertise the flex-algo definition, This is the first step in creating a flex-algo instance, and it's done by defining the flex-algo instance and its properties on one or more routers in the network.
The other steps are important to fine-tune the flex-algo instance, but not mandatory to create it.
Configuring the proper values for the shared-risk link groups (SRLGs) that will define the flex-algo topology.
Specifying whether the LSP paths will be computed locally or by an external path computation element (PCE).
Configuring LSPs between every pair of PE routers.
The exhibit presents packets being transmitted inside an LSP's multi-segment primary path going from router R1 to router R8. The LSP also has a standby secondary path, and Seamless-BFD has been enabled on the primary path. The link between routers R1 and R2 fails, and fast re-route (FRR) is triggered. As a result, router R1 forwards the packets to router R3 and adds the proper FRR encapsulation to reach which router?
- Select Question Types you want
- Set your Desired Pass Percentage
- Allocate Time (Hours : Minutes)
- Create Multiple Practice tests with Limited Questions
- Customer Support
Kizzy
2 months agoJutta
2 months agoJennie
3 months agoDarnell
3 months agoArthur
4 months ago