Free Preparation Discussions
MENU
NetApp NS0-181 Exam Questions
- Topic 1: Basic Installation Topics and Tools/ Describe Installation Preparation Steps, Basic Equipment Installation Steps
- Topic 2: ONTAP Concepts/ Identify General Cluster Terms Used During Installation, ONTAP Licensing for 9.1
- Topic 3: ONTAP Networking/ Describe the Cluster Network, Demonstrate Knowledge of the Purpose of the Management Network
- Topic 4: ONTAP Switches/ Identify the Functions of Supported Switches/ Demonstrate Knowledge of How to Configure/Verify Configuration Requirements
- Topic 5: ONTAP Configuration and Troubleshooting/ Customer Handoff
- Topic 6: Demonstrate Knowledge of How a Node Should be Added or Replaced, Handoff Procedures to the Customer, How to Communicate Completion and Possible Problem Status
- Topic 7:
Free NetApp NS0-181 Exam Actual Questions
Note: Premium Questions for NS0-181 were last updated On 08-07-2019 (see below)
You are preparing to install a new cluster at a customer site.
Which two concerns must you address with the customer in this scenario? (Choose two.)
Select the Exhibit tab.
You install a new FAS2650 HA with a DS224C disk shelf and ONTAP 9.1 on a customer site.
Referring to the exhibit, which two statements describe what is required to get an HA cabled system? (Choose two.)
Recently, your 2-node FAS8020 cluster was upgraded from ONTAP 8.3 to ONTAP 9.1. You have just added two FAS8060 nodes to the cluster. You have executed Config Advisor to verify your work. Config Advisor tells you that the cluster ports on the original two FAS8020 nodes have Flow Control set to FULL.
In this scenario, to what should the Flow Control setting on the FAS8020 ports be set?
You have a 4-node FAS8060 cluster. You are using the vol move command to relocate a volume from an aggregate on node 1 to an aggregate on node 4.
In this scenario, which network is used for the traffic being relocated?
You install and apply the NetApp RSCF on cluster interconnect switches.
Which two statements are correct in this scenario? (Choose two.)
- Select Question Types you want
- Set your Desired Pass Percentage
- Allocate Time (Hours : Minutes)
- Create Multiple Practice tests with Limited Questions
- Customer Support
Currently there are no comments in this discussion, be the first to comment!