Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Microsoft Exam MB-330 Topic 6 Question 86 Discussion

Actual exam question for Microsoft's MB-330 exam
Question #: 86
Topic #: 6
[All MB-330 Questions]

A company uses Dynamics 365 Supply Chain Management.

You create a product by using an incorrect product dimension group. The product has not yet been released to the legal entities.

You need to determine whether you can change the product dimension group.

Which two conditions must be met? Each answer presents part of the solution.

NOTE: Each correct selection is worth one point.

Show Suggested Answer Hide Answer
Suggested Answer: A, D

Changing the product dimension group for a product master

The setup of the product dimension group for a product master can be changed if the product master has not been released, and if no dimensions have been created.

Otherwise, the following rules apply:

If a product master has been shared, the setup of the product dimension group cannot be changed. This rule applies both to the shared instance of the product master and to any company-specific instances.

If a product master is created as a released product master, the product dimension group cannot be changed.

If dimensions have been created for a product master, the product dimension group cannot be changed. However, if the dimension setup of a new product dimension group is identical to the dimension setup of the original product dimension group, the new product dimension group can be changed.


Contribute your Thoughts:

Ty
11 months ago
Hmm, I'm not so sure about the 'dimensions must be specified that match the original but not the new product dimension group' part. That seems a bit convoluted to me. Why would you need to match the original dimensions but not the new ones?
upvoted 0 times
...
Lindsey
11 months ago
Ah, yes, that's a good point. The item has to not be validated yet. Otherwise, you're kind of stuck with the original product dimension group.
upvoted 0 times
...
Donte
11 months ago
I agree with that, but I also think the item can't already be validated. If it's been validated, then I don't think you can change the product dimension group anymore.
upvoted 0 times
Kenneth
11 months ago
We need to make sure all these conditions are met before changing the product dimension group.
upvoted 0 times
...
Isreal
11 months ago
Also, the product master must not be released to any legal entities.
upvoted 0 times
...
Keena
11 months ago
Exactly, and the item must not already be validated.
upvoted 0 times
...
Penney
11 months ago
So, the dimensions must not be specified for the product master.
upvoted 0 times
...
Carey
11 months ago
That's correct. The product master must not be released to any legal entities.
upvoted 0 times
...
Avery
11 months ago
I think the item must not already be validated.
upvoted 0 times
...
Zita
11 months ago
Yes, I agree. Dimensions must be specified that match the original but not the new product dimension group.
upvoted 0 times
...
...
Bronwyn
11 months ago
Hmm, this question seems pretty straightforward. I think the key conditions are that the product hasn't been released to any legal entities and that the dimensions must not be specified for the product master. Those seem like the most important things to me.
upvoted 0 times
...

Save Cancel