Juniper Exam JN0-250 Topic 1 Question 5 Discussion

Actual exam question for Juniper's JN0-250 exam

Question #: 5
Topic #: 1

You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected to an 802. 3at-capable switch.

In this scenario, what would be the cause of the error?

AThe cable run to each AP is too long.

BThe Ethernet cable is plugged into the wrong port on the AP.

CThe APs' firmware must be upgraded.

DLLDP-MED is not configured on the switch.

Show Suggested Answer

Suggested Answer: C

by Abel at May 10, 2022, 01:17 AM

Limited Time Offer

25%

Off

Get Premium JN0-250 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!