IBM Exam C2090-600 Topic 10 Question 20 Discussion

Actual exam question for IBM's C2090-600 exam

Question #: 20
Topic #: 10

[All C2090-600 Questions]

The HADR_TARGET_LIST parameter enables HADR to run in multiple standby mode. Which of the following statements are TRUE if HADR is active? (Choose two.)

AYou can change the principal standby of the primary without first stopping HADR on the primary.

BThe target list can contain IP addresses that are either IPv4, or IPv6, or a combination of the two.

CYou can remove the primarydatabase from the target list of a standby although the standby is connected to the primary.

DYou cannot dynamically update the HADR_TARGET_LIST configuration parameter for a standby unless you have enabled the HADR read standby feature.

EYou cannot remove a standby from the list if it is connected to the primary. To disconnect a standby, simply deactivate it. The you can remove it from the primary's target list.

Show Suggested Answer

Suggested Answer: A, E

by Candida at May 05, 2022, 03:51 AM

Limited Time Offer

25%

Off

Get Premium C2090-600 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!