Huawei Exam H12-722 Topic 1 Question 17 Discussion

Actual exam question for Huawei's H12-722 exam

Question #: 17
Topic #: 1

Configure the following commands on the Huawei firewall:

[USG] interface G0/0/1

[USG] ip urpf loose allow-defult-route acl 3000

Which of the following options are correct? (multiple choice)

AFor loose inspection: if the source address of the packet exists in the FB of the firewall: the packet passes the inspection directly

BFor the case where the default route is configured, but the parameter allow-defult-route is not configured. As long as the source address of the packet is in the FIB table of the firewall
If it does not exist, the message will be rejected.

CFor the situation where the default route is configured and the parameter allow-defult-route is matched at the same time, if the source address of the packet is in the FIB table of the firewall
If the packet does not exist in the loose check mode, all packets will pass the URPF check and be forwarded normally.
155955cc-666171a2-20fac832-0c042c0427

DFor the configuration of the default route, and at the same time matching the parameter allow-defult-route, if the source address of the message is in the FIB table of the firewall
If it does not exist in the l0e check, the packet cannot pass the URPF check.

Show Suggested Answer

Suggested Answer: A, B, C

by Rebecka at May 03, 2022, 11:40 PM

Limited Time Offer

25%

Off

Get Premium H12-722 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!