Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions

Huawei Exam H12-261_V3.0 Topic 1 Question 41 Discussion

Actual exam question for Huawei's H12-261_V3.0 exam
Question #: 41
Topic #: 1
[All H12-261_V3.0 Questions]

As shown in the figure, the router load shares the communication traffic between branch network 1 and branch network 2. In this case, configure the configuration on the physical interface of the router.

URPF must use loose mode to prevent source IP address spoofing attacks.

Show Suggested Answer Hide Answer
Suggested Answer: A, B, C, D

Contribute your Thoughts:

Kenneth
10 months ago
B) Yes, and if the RP is not properly elected or configured, it can lead to multicast issues.
upvoted 0 times
...
Felix
10 months ago
A) That makes sense, without a proper unicast route the RPF check fails.
upvoted 0 times
...
Colene
11 months ago
D) Maybe RTA is not statically configured with the RP, causing the issue.
upvoted 0 times
...
Tatum
11 months ago
C) The RP elected by RTA is not RTB, that could be the reason why RIB cannot see the multicast source.
upvoted 0 times
...
Val
11 months ago
B) I think the issue could be related to the RP election process.
upvoted 0 times
...
Francoise
11 months ago
A) There is no unicast route from RTB to RTA, which causes RTB to fail the RPF check of the source.
upvoted 0 times
...

Save Cancel