Name: HP HP2-Z34 Exam
Brand: Pass4Success
SKU: HP2-Z34
Price: 69.00 USD
Availability: InStock
Rating: 4.7 (121 reviews)

Disscuss HP HP2-Z34 Topics, Questions or Ask Anything Related

Submit Cancel

Currently there are no comments in this discussion, be the first to comment!

Free HP HP2-Z34 Exam Actual Questions

Note: Premium Questions for HP2-Z34 were last updated On 25-07-2017 (see below)

Question #1

Refer to the exhibit

An MPLS Layer 2 VPN is being implemented between Sites 1 and 2. The administrator wants PE-1 and PE-2 to set up the Virtual Circuit (VC) dynamically by using the Martini method. What is required to accomplish this goal?

Aredistribution of Border Gateway Protocol (BGP) routes into Open Shortest Path First (OSPF) on PE-1 and PE-2

Bremote LDP session between PE-1 and PE-2

CiPSec tunnel between PE-1 and PE-2

DVPN instance with the same route distinguisher (RD) on PE-1 and PE-2

Reveal Solution

Correct Answer: A

Question #2

Refer to the exhibit

SPBM is being implemented on the backbone links shown in the exhibit. The servers in VLAN 10 (10.1.10.0/24) should be able to communicate at Layer 2 across the backbone. In the vsi section of the configuration on Switch 1. which logical components are required?

Athe S-VLAN to which the servers are assigned and the ECT algorithm for distributing their traffic

Ba unique l-SID for the servers and the B-VLAN that should carry their traffic

Cthe S-VLAN to which the servers are assigned and the B-VLAN that should carry their traffic

Da unique l-SID for the servers and the S-VLAN to which the servers are assigned

Reveal Solution

Correct Answer: C

Question #3

Which statement is correct about a Fibre Channel (FC) World Wide Name (WWN)?

AIt is a hardware specific address for a LUN on a storage disk and can be used to direct FC frames to targets.

BIt is a hardware specific address for an FC device and can be used to place the device in zones.

CIt is assigned to an FC device based on its location and can be used to deliver FC frames

DIt is assigned to an FC N-port as its switch joins the fabric and can be used to route FC frames

Reveal Solution

Correct Answer: A

Question #4

Refer to the exhibit

An HP Comware switch is configured to support FCoE in Fibre Channel Forwarder (FCF) mode Serverl should be able to discover storage targetl and target2. but not target3 Assume that the zone-aliases have been configured to reference the FC devices correctly

Which zone(s) should be added to the active zoneset?

Azone 1, zone 2, and zone 3

Bzone 1 and zone 5

Czone 4

Dzone 6

Reveal Solution

Correct Answer: B

Question #5

Refer to the exhibit

A VSAN is being set up on an HP Comware switch that will connect to server Converged Network Adapters (CNAs) and storage systems The administrator is checking the configuration of the VSAN with display commands The exhibit shows the results.

What is a potential issue?

AThe current zoning configuration does not permit any communication.

BThe fabric name has been set to the same ID as the switch WWN. which causes conflicts.

CThe distribute mode for zones has been set to active only, which can cause issues with redundancy.

DThe domain ID has been set manually to a preferred ID, but this switch does not have the highest priority

Reveal Solution

Correct Answer: D

Unlock Premium HP2-Z34 Exam Questions with Advanced Practice Test Features:

Select Question Types you want
Set your Desired Pass Percentage
Allocate Time (Hours : Minutes)
Create Multiple Practice tests with Limited Questions
Customer Support

Get Full Access Now