BlackFriday 2024! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

HP Exam HPE0-S59 Topic 6 Question 29 Discussion

Actual exam question for HP's HPE0-S59 exam
Question #: 29
Topic #: 6
[All HPE0-S59 Questions]

Your customer has an HPE Synergy frame equipped with a D3940 Storage Module. Each of the compute nodes has an appropriate storage controller Installed and two 12Gb SAS switches installed in the first fabric.

The customer reports that compute nodes cannot access the storage module. What should you verify first when troubleshooting this problem?

Show Suggested Answer Hide Answer
Suggested Answer: A

by Theodora at Feb 08, 2024, 04:47 PM

Limited Time Offer

25%

Off

Get Premium HPE0-S59 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Felice
5 months ago
Good point, licensing could be an issue preventing access to the storage module.
upvoted 0 times
...
Nada
5 months ago
I think we should also confirm if the storage module is properly licensed through HPE OneView interface.
upvoted 0 times
...
Willetta
6 months ago
That's true, we need to make sure the compute nodes can communicate with the storage module through the switches.
upvoted 0 times
...
Daren
6 months ago
But shouldn't we also check if there is a logical interconnect created based on the SAS switches?
upvoted 0 times
...
Felice
6 months ago
I agree with Willetta, that's the first thing we should verify.
upvoted 0 times
...
Willetta
6 months ago
I think we should check if the D3940 module is imported in the correct state.
upvoted 0 times
...

Save Cancel