Free Preparation Discussions
MENU
Dell EMC E20-260 Exam Questions
- Dell EMC Implementation Engineer Certifications
- Dell EMC VPLEX Specialist Certifications
- Topic 1: Basic troubleshooting on various VPLEX elements/ VPLEX product hardware and software architecture
- Topic 2: VPLEX events and system reports to an ESRS Gateway/ VPLEX terminology and configurations
- Topic 3: Port Identification and Installation Utilities/ Installing VPLEX usingEMC procedures
- Topic 4: Device and extent management on VPLEX devices/ Protecting VPLEX with RecoverPoint
- Topic 5: Expanding a VPLEX topology/ Provision storage to VPLEX back-end ports
- Topic 6: Creating VPLEX Distributed Devices/ VPLEX applicationof VS2 and VS6 technology and upgrading from VS2 to VS6
- Topic 7: Data collection processes/ VPLEX Installation and Setup/ Site Installation Preparation
- Topic 8: VPLEX Upgradesand Troubleshooting/ Performing data migration using VPLEX
- Topic 9: Integrating VPLEX into an existing environment and encapsulating storage/ VPLEX Storage Provisioning
- Topic 10: Analyze monitoring data in VPLEX/ Setupperformancemonitors in VPLEX/ Virtual Volume Provisioning
Free Dell EMC E20-260 Exam Actual Questions
Note: Premium Questions for E20-260 were last updated On 28-05-2024 (see below)
Refer to the exhibit.
The customer deleted ext_2 on a 20 GB LUN in order to make an extent of 10 GB. Why is the customer unable to create a 10 GB extent?
Refer to the exhibit.
Reference the message type shown at point "1". What type of response will be sent back to the SNMP management server from the SNMP Agent?
Refer to the exhibit.
You are preparing to perform an upgrade on an unconfigured VPLEX Metro. When you run the ndu pre-check command, it indicates that it has failed and there are no first upgraders. In your troubleshooting, you run the version -a command.
Based on the output, what is the reason for the failure?
Refer to the exhibit.
You have created a Distributed Device in a VPLEX Metro. You want to confirm the volumes before performing a mobility job within the cluster. You will be moving the device to cluster 1.
Which object will be the source for this operation?
- Select Question Types you want
- Set your Desired Pass Percentage
- Allocate Time (Hours : Minutes)
- Create Multiple Practice tests with Limited Questions
- Customer Support
Currently there are no comments in this discussion, be the first to comment!