A RecoverPoint cluster with two RPAs and VPLEX splitter has been deployed. When you run the rp validate-configuration VPLEX CLI command, the error shown in the exhibit is displayed.
Hmm, I'm not too sure about this one. But if I had to guess, I'd say the RPAs aren't properly zoned to the VPLEX ports. That's got to be the issue, right?
This error seems to be caused by a problem with the zoning between the RPAs and the VPLEX ports. The correct answer is likely D - The RPAs are not zoned to the VPLEX FE ports.
Hui
4 months agoJerry
4 months agoRodney
4 months agoMirta
4 months agoRoosevelt
4 months agoTommy
4 months agoHaydee
4 months agoJeannetta
4 months agoVashti
4 months agoFelicidad
5 months agoGoldie
5 months agoAlyssa
4 months agoLouvenia
4 months agoFernanda
4 months agoShay
5 months ago