Dell EMC Exam D-RP-OE-A-24 Topic 2 Question 16 Discussion

Actual exam question for Dell EMC's D-RP-OE-A-24 exam

Question #: 16
Topic #: 2

An administrator ran the balance_load command on a RecoverPoint cluster during a high-load issue. However, the administrator forgot to capture the output. Where can the

RecoverPoint Cluster Load report be located?

AIn the output from running the 'Collection System Information' wizard

Bhttps://Cluster_Management_IP/info/long_term_statistics

Chttps://Cluster_Management_IP/info/load_balancing/

DIn the output from the events_log

Show Suggested Answer

Suggested Answer: C

After running the balance_load command on a RecoverPoint cluster, if the administrator did not capture the output, the RecoverPoint Cluster Load report can be found at the specific URL provided by the RecoverPoint management interface. The correct URL format to access this report is https://Cluster_Management_IP/info/load_balancing/, where Cluster_Management_IP is replaced with the actual IP address of the RecoverPoint cluster management interface1.

The steps to locate the report are

by Henriette at Oct 25, 2024, 12:35 AM

Limited Time Offer

25%

Off

Get Premium D-RP-OE-A-24 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Linsey

1 days ago

I'm going with C. The admin should have checked the load balancing info page on the cluster management IP. That's where the magic happens!

upvoted 0 times

...

Alva

6 days ago

Ah, the good old balance_load command. Sounds like the admin was trying to 'balance the load' on their cluster, but forgot to save the evidence. Classic IT move!

upvoted 0 times

...

Louann

8 days ago

I believe it might also be located at https://Cluster_Management_IP/info/long_term_statistics. Let's check both options to be sure.

upvoted 0 times

...

Kenneth

10 days ago

Hmm, I'm not too sure about this one. Maybe B would be the best bet since it mentions 'long_term_statistics'.

upvoted 0 times

...

Enola

11 days ago

I think the RecoverPoint Cluster Load report can be found in the output from running the 'Collection System Information' wizard.

upvoted 0 times

...

Tiffiny

13 days ago

D looks like the correct answer to me. The output from the events_log should contain the details of the balance_load command that was run.

upvoted 0 times

...

Skye

16 days ago

I think the answer is C. The RecoverPoint Cluster Load report should be located at the /info/load_balancing/ URL on the cluster management IP address.

upvoted 0 times

Whitney

7 days ago

Yes, you are correct. The RecoverPoint Cluster Load report can be found at the /info/load_balancing/ URL.

upvoted 0 times

...

Linwood

9 days ago

I think the answer is C.

upvoted 0 times

...