Dell EMC Exam D-OME-OE-A-24 Topic 6 Question 19 Discussion

Actual exam question for Dell EMC's D-OME-OE-A-24 exam

Question #: 19
Topic #: 6

An administrator has configured a server to meet company-mandated BIOS settings and captured these settings in a Deployment Template.

They are trying to apply these settings to a new server. When the Template Deployment wizard is run, the server is not listed as a possible target.

Which of the following could cause this issue?

AThe new server has multiple network cards.

BThe new server does not have the required license.

CThe new server is not part of the bare metal pool.

DA template can only be deployed to the server it is captured from.

Show Suggested Answer

Suggested Answer: C

When deploying a Deployment Template in OpenManage Enterprise and the target server is not listed, it could be due to the server not being part of the bare metal pool. The bare metal pool is a collection of servers that have been discovered but not yet configured or assigned to any specific group or task within OpenManage Enterprise. If a server is not part of this pool, it may not be recognized as a potential target for template deployment.

Here are the steps and considerations that might be involved in resolving this issue:

Verify Server Discovery: Ensure that the new server has been discovered by OpenManage Enterprise and is listed in the inventory.

Check Bare Metal Pool Membership: Confirm that the server is part of the bare metal pool, which is a prerequisite for deploying templates to unconfigured servers.

Review License Requirements: Make sure that the server has the necessary OpenManage Enterprise Advanced or Advanced Plus license installed, as this is required for deploying certain templates1.

Template Compatibility: Ensure that the Deployment Template is compatible with the new server's model and configuration.

For detailed guidance on creating and deploying server templates, including troubleshooting steps for when servers are not listed as targets, you can refer to the official Dell EMC OpenManage Enterprise User's Guide1 and support videos2.

=========================

by Lourdes at Feb 07, 2025, 10:23 AM

Limited Time Offer

25%

Off

Get Premium D-OME-OE-A-24 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Dana

10 days ago

But could it also be that the template can only be deployed to the server it was captured from?

upvoted 0 times

...

Glory

17 days ago

I agree with Leana. If the server is not part of the pool, it won't show up as a target.

upvoted 0 times

...

Leana

19 days ago

I think the issue might be that the new server is not part of the bare metal pool.

upvoted 0 times

...

In

22 days ago

The correct answer is C. The new server must be part of the bare metal pool to be a valid target for the Template Deployment wizard. This makes sense since the template is capturing specific BIOS settings that are tied to the server hardware.

upvoted 0 times

Narcisa

8 days ago

C) The new server is not part of the bare metal pool.

upvoted 0 times

...

Valentin

15 days ago

A) The new server has multiple network cards.

upvoted 0 times

...