Deal of The Day! Hurry Up, Grab the Special Discount - Save 25% - Ends In 00:00:00 Coupon code: SAVE25
Welcome to Pass4Success

- Free Preparation Discussions
Mail Us support@pass4success.com
Location US
Mob_nav_barsMENU

CyberArk Exam PAM-CDE-RECERT Topic 3 Question 44 Discussion

Actual exam question for CyberArk's PAM-CDE-RECERT exam
Question #: 44
Topic #: 3
[All PAM-CDE-RECERT Questions]

You have been asked to configure SNMP remote monitoring for your organization's Vault servers. In the PARAgent.ini, which parameter specifies the destination of the Vault SNMP Traps?

Show Suggested Answer Hide Answer
Suggested Answer: A

by Nicolette at Dec 05, 2024, 02:29 PM

Limited Time Offer

25%

Off

Get Premium PAM-CDE-RECERT Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel
Yuonne
2 days ago
D) SNMP Version? Nah, that's not for the trap destination. I'm stumped on this one.
upvoted 0 times
...
Patrick
3 days ago
Wait, isn't it C) SNMPCommunity? I remember something about that in the SNMP configuration guide.
upvoted 0 times
...
Martina
12 days ago
I think the correct parameter is SNMPCommunity, as it specifies the community string for SNMP communication.
upvoted 0 times
...
Minna
13 days ago
But SNMPHostIP is for specifying the IP address of the SNMP server, not the destination of the traps.
upvoted 0 times
...
Chauncey
19 days ago
I'm pretty sure it's A) SNMPHostIP. I mean, where else would the traps go?
upvoted 0 times
...
Alayna
21 days ago
I disagree, I believe it is SNMPTrapPort.
upvoted 0 times
...
Minna
26 days ago
I think the parameter that specifies the destination of the Vault SNMP Traps is SNMPHostIP.
upvoted 0 times
...
Nakita
1 months ago
Hmm, let's see... I think the answer is B) SNMPTrapPort. That's where the traps get sent, right?
upvoted 0 times
Hyun
12 days ago
No problem! It's important to have the correct configuration for SNMP remote monitoring to work effectively.
upvoted 0 times
...
Glenn
16 days ago
Thank you for confirming! I'll make sure to double-check the SNMPTrapPort parameter in the PARAgent.ini file.
upvoted 0 times
...
Cheryl
23 days ago
Make sure to configure the SNMPTrapPort with the correct port number to ensure the traps are sent to the right destination.
upvoted 0 times
...
Krystal
30 days ago
Yes, you are correct! SNMPTrapPort is the parameter that specifies the destination of the Vault SNMP Traps.
upvoted 0 times
...
...

Save Cancel