Citrix Exam 1Y0-241 Topic 2 Question 84 Discussion

Actual exam question for Citrix's 1Y0-241 exam

Question #: 84
Topic #: 2

Scenario: A Citrix Administrator configures an Access Control List (ACL) to block traffic from the IP address 10.102.29.5:

add simpleacl rule1 DENY -srcIP 10.102 29.5

A week later the administrator discovers that the ACL is no longer present on the Citrix ADC.

What could be the reason for this?

AThe administrator did NOT run the apply ACL command.

BThe simple ACLs remain active for only 600 seconds.

CThe simple ACLs remain active for only 60 seconds.

DThe Citrix ADC has been restarted without saving the configurations.

Show Suggested Answer

Suggested Answer: D

by Fredric at Sep 17, 2024, 06:10 PM

Limited Time Offer

25%

Off

Get Premium 1Y0-241 Questions as Interactive Web-Based Practice Test or PDF

Contribute your Thoughts:

Submit Cancel

Kris

4 months ago

Restarting without saving? Yikes, that's a surefire way to lose all your hard work. Gotta remember to hit that 'Save' button, folks.

upvoted 0 times

Ira

3 months ago

C: The administrator should be more careful next time to avoid losing the ACL settings.

upvoted 0 times

...

Bulah

3 months ago

B: Yeah, always remember to save your configurations before restarting.

upvoted 0 times

...

Laine

3 months ago

A: The Citrix ADC has been restarted without saving the configurations.

upvoted 0 times

...

Tomas

4 months ago

Hold up, are you telling me these simple ACLs only last for a minute? Talk about a short attention span!

upvoted 0 times

Gracia

3 months ago

Or maybe they didn't run the apply ACL command to make it active.

upvoted 0 times

...

Timmy

4 months ago

Maybe the administrator forgot to save the configurations after setting up the ACL.

upvoted 0 times

...

Anglea

4 months ago

Yeah, it's crazy how short-lived those simple ACLs are.

upvoted 0 times

...

Luisa

4 months ago

But what if the administrator forgot to run the apply ACL command?

upvoted 0 times

...

Alonzo

4 months ago

I agree with Micaela, the Citrix ADC might have been restarted without saving the configurations.

upvoted 0 times

...

Demetra

4 months ago

Whoa, looks like the Citrix admin forgot to hit the 'Apply ACL' button. Rookie mistake, am I right?

upvoted 0 times

Bette

3 months ago

The apply ACL command is crucial for it to take effect.

upvoted 0 times

...

Justa

4 months ago

It could be that the ACLs have a time limit.

upvoted 0 times

...

Mona

4 months ago

Maybe they didn't save the configurations before restarting.

upvoted 0 times

...

Celestina

4 months ago

Yeah, that's a common mistake.

upvoted 0 times

...

Micaela

5 months ago

I think the reason could be option D.

upvoted 0 times

...